bat365 Homepage - Welcome

Help Center Help Center

Fault Detection, Isolation, and Recovery

Design algorithms to identify and manage system failures

Enable your safety-critical model to recover from system failures by using redundant logic and explicit transitions for every state. When system faults occur, detect and isolate them by using operating points. Test your model at specific fail times without rerunning the entire simulation.

Topics

Design for Isolation and Recovery in a Chart
Detect system faults and recover from failure modes.
Test Chart with Fault Detection and Redundant Logic
Check the response of an aircraft elevator system to an actuator failure.

Featured Examples

Launch Abort System

Launch Abort System

Model a launch abort system for an orbiter.

Detect Faults in Aircraft Elevator Control System

Detect Faults in Aircraft Elevator Control System

Design a fault detection, isolation, and recovery (FDIR) application for a pair of aircraft elevators controlled by redundant actuators.

Model a Redundant Sensor Pair by Using Atomic Subcharts

Model a Redundant Sensor Pair by Using Atomic Subcharts

Compose a large Stateflow^® chart by using linked atomic subcharts in a library file.

Model a Fault-Tolerant Fuel Control System

Model a Fault-Tolerant Fuel Control System

Combine Stateflow and Simulink^® to model hybrid systems.